Most submersible well pumps in Florida last 8 to 15 years, and Pasco & Hillsborough Counties's groundwater carries moderate mineral content that can accelerate motor wear compared to drier climates elsewhere in the country. When a pump reaches end-of-life, repair stops being the economical choice — we handle the full replacement process, not just the pump swap.
What's Involved in a Full Replacement
A complete replacement includes pulling the existing submersible pump, inspecting the drop pipe and wiring for wear or damage, evaluating the pressure tank (a worn tank is a common cause of premature failure in the new pump too), and installing a correctly sized replacement motor for your specific well depth. We test the full system — pressure, flow rate, and cycling — before considering the job complete.
Repair or Replace?
As a rule of thumb: if your pump is under 8 years old and the failure is electrical (switch, capacitor, wiring), repair usually makes sense. If it's over 10 years old, has failed more than once in the past two years, or the motor itself has burned out, replacement is typically the better long-term value — a repaired 12-year-old motor is still a 12-year-old motor. We'll give you a straight answer on which situation you're in rather than defaulting to whichever is more profitable for us.
What Replacement Costs
Full well pump replacement across Pasco & Hillsborough Counties typically runs $1,500–$3,500 depending on pump type and well depth, similar to new installation pricing since the scope of work — pull, inspect, replace, test — is largely the same. If your pressure tank also needs replacement, we'll flag that separately in your written estimate rather than bundling it in without explanation.